Calrad 40-2015 HDMI 4K@60 4.4.4 BALUN BI DIRECTIONAL IR 210 FT
List Price: $351.00
$
You save $!
Manufacturer:: Calrad Electronics
Product Code: Wal22-40-2015
40-2015 | HDMI 4K x 2K \ 60hz Balun with IR over Single CAT5e/6 Cable (Sold in Pairs) The 40-2015 balun provides a single UTP category 5e/6 cable solution to deliver pristine digital signals from all HDTV formats and signal sources from 480i/p to1080i/p, 4K x 2K \ 60hz. Provides IR and EDID support to the receiver for a single cable solution. Typical Hookup, Diagram 1A below for connectivity details.
Please Note! the following information when using this product Signal transmission distances may vary and are dependent on manufactures individual HDMI specifications and the quality and type of UTP cable used. All products should be fully tested prior to committing to a UTP Cat5e, Cat6 solution and running long runs of cables inside walls, possibly compromising your installation. All UTP wiring and RJ45 connectivity start to finish should be certified to 568A or 568B standards and tested before connecting the Transmitter to the Receiver.
Note!!! For further technical assistance or questions regarding connectivity and termination or for IR control related configurations or IR specific questions, please contact our technical support department, Tel: (323) 465-2131, M-F 8:00 am to 2:00 pm.
Typical Connectivity
Package Contents: 1 x 40-2015 Transmitter, 1 x 40-2015 Receiver, 1 x DC Power Supply, 1 x IR Receiver, 1 x IR Emitter
UTP Cable Distance: CAT5e 70M (229Ft.)@1080i, CAT5 45M, CAT6 70M (229Ft.) at up to1080i\p CAT6 40M (130Ft.) at 4K x 2K
Audio Support: LPCM 7.1, DTS Digital, Dolby Digital, DTS-HD and Dolby True HD
IR Carrier Frequency: 30Khz ~ 60Khz (Non-Flashing Emitter works with IR-UV STB)
IR Input/Output Connectors: 1 x 3.5mm Mono Jacks each unit
HDMI ln/Out Connectors: 19 pin Female Jack, 1 x RJ45 Shielded Jack each unit
IR Receiver IR Emitter Cable Length’s: 3 ft.
DC Power Supply: 1 x 12V, 1Amp Regulated
Color: Black
Weight: 10.76oz each unit
Dimensions (Transmitter, Receiver)(in): 2.98" L x 2.84" W x 0.71" H
Mounting: Transmitter, Receiver 4 x Mounting Holes
EDID Settings on Transmitter Side Only (2 PIN DIP Switch): [0,0] Default 4K@60, YUV: 4:2:0-2CH, [1,0] Copy EDID from loop out display, [0,1] Copy EDID from display on the Receiver and [1,1] Default 4K@60, YUV: 4:4:4-5.1CH.
Note!!! The transmitter has default EDID and copy EDID function, default EDID includes 4K@60hz and 1080P@60hz, Copy EDID includes copy of the loop out display or display on the receiver side by the 2 PIN DIP switch. Up dial stands for 0, down dial stands for 1, different digits combination has different EDID effect according to the 2 Pin Dip Switch combinations mention above.
